Get configuration information

Instructions

In order to create an su module, from this directory,

 you will need access to the self-instructions of the
 seismic unix module, which I find in:
  /usr/local/cwp_su_all_48/src/doc/Stripped

 1. modify the following:

  sudoc2pm.pl

  by adding a line, such as the following:
        $file_in[0]                             = 'xgraph.Xtcwp.main';

 2. run the following:

  perl sudoc2pm.pl ( under ~L_SU)

sub file_dialog_type_aref

  The type of dialog (Data, Path, Flow, SaveAs) is needed during MB3 binding
  Use one type of dialog for each index
  
  'Flow' will go to PL_SEISMIC by default
  'Flow' creates a directory path on the parameter value in GUI (why -- TODO)
  
  'Data' will go to seismic su data by default or
  whatever the *_spec file defines the DATA_DIR_IN or DATA_DIR_OUT which could be,
  e.g. PL_SEISMIC
  'Data' does not create a directory path on the parameter value in GUI (why -- TODO)
  
  'Path' searches for only a directory PATH
  
  SaveAs goes to  PL_SEISMIC
 
  _DATA_DIR_IN              => $DATA_SEISMIC_SU,
  _DATA_DIR_OUT             => $PL_SEISMIC,      
  
  

sub binding_index_aref

CASE:

  Interactive general x-t picking 

CASE:

  Interactive general x-t picking